Here I have mapped out some ideas of what I can do with some of my final print outs, I have added a lot of borders, mainly to be able to see them properly online, but I do believe that it could a special effect to some of the photos, as some of the photos don’t have much going on in them, then the add of a border can make it stand out a lot more than rest. For the first one. I’ve decided to put 3 final photos together, I put the simpler one in the middle to make sure it gets as much recognition as the other and the more detailed ones are on the outside, the 2 photos on the side consist of 3 characters on the models head or around it. I made sure to put a border on each of the photos and then a border on top of that, this makes the photo stand out a lot more and adds dimension to the final piece. For the second final piece I’ve decided to put 4 photos together, these photos will be in the smallest print size to make sure the final piece isn’t too big. I’ve put these 4 photos together as they create a good dimension, I really like how these turned out, I also made sure it was layered it in borders to make the photos look 3D. Next, these photos were in black and white therefore I didn’t think that it needed a strong border, so I only added one instead of 3 as the colours in the photo grab enough attention and don’t need to have a big border to divert the attention somewhere else. I also wanted to have some mounts that aren’t too basic, although all of my mounts consist of just simple borders I believe that my photos don’t need big and detailed borders as that can distract the whole concept of the photo. For the last mount that I have selected I made it have loads of boarders which increased the dimension of the photograph, since the photo is in black and white and almost looks quite sketchy I thought having some dimension might make it look cooler.